Advanced Search|Search Tips
MOTOR, 1/2HP,90VDC,WASH DOWN, 56CFACE Motor for Conveyors.
Motor, 1/2HP, 1750RPM, 90VDC This motor is used on APACKS Conveyors & Cappers Use the E-PAK Part Number...
SEAL, GEAR BOX OUTPUT SHAFT USE ON 1092-100 AND 1092-108
SEAL, GEAR BOX INPUT SHAFT USE ON 1092-100 AND 1092-108
DC Motor Control Board Resistor Each KBIC Board needs a horse power resister, sized for the motor.
DC Motor Control Board For DC motor control on cappers, conveyors, and similar machines. Board controls min/max and acceleration of motor speed range. Plug in resistors from 1/100 to 1 HP (see chart below). Horse Power...
Manual speed controller used for adjusting the speed on AC drive conveyors.
Used for speed regulation on AC motor control use on AC drive turntables and conveyors. 0-400RPM when used with 1800RPM motor. Motor direction: both clockwise and counter clockwise.
Used for speed regulation on AC motor control use on AC drive turntables and conveyors. 0-400RPM when used with 1800RPM motor. Motor direction: clockwise.
Used for speed regulation on AC motor control use on AC drive turntables and conveyors. 0-400RPM when used with 1800RPM motor. Motor direction: counter clockwise.
COVER, SHAFT FOR REDUCERS
Gear Reducer, 36:1 Bravo Gear reducer used for conveyor drive. * Do Not mix Lubricants in the reducer. If oil is needed, drain the gear box and replace all of the oil...
Gear reducer used for conveyor drive. NOT Available, and has been replaced by: 1092-100
Motor, 1/2HP, 1750RPM, 90VDC Motor drive for Conveyors and 4 Station Capper, (sometime the 3 Staion Capper) (Spindle Drive).